Optimum Control of your Flexo Plates and Sleeves
X|Y|Z readings, Screen Count, Percentage, Relief Depth, Compression Simulation, Angles
The FlexoPlate QC Workflow
The AniCAM Flexoplate QC Workflow provides two reading methods: 2-dimensional readings with an automatic reflective or translucent dot detection and a 3-dimensional analysis which provides additional information on dot shape, height and relief depths.
Quality Control is Essential
Printers often charge trade-houses for lost productivity if the fault is proven to be theirs – trade houses need to check and maintain their quality to ensure they meet their customers needs.
The time and cost of defective plates will increase waste, reduce productivity and profitability
Cost savings made over time through Quality Control on dot shape, relief depths and dot sizes can be significantly high and will result in a fast Return of Investment.
Any Flexo Plate material and Sleeves – flat or in the round, Direct laser engraved Elastomer plates and sleeves
Halftone dots from 55 to 250 lpi | 22 – 100 lpcm, Accuracy: ± 0.5% over full range of readings, 2D and 3D visual and graphical dot analysis, Geometric measurements.
Dynamic Graphic Display
Screen Angle/Ruling calculation
.fcp format (incl. 2D/3D info); JPEG and BMP (bitmap export)
1 co-axial and 2 x 9 radial white light LEDs (SW-controlled)
USB2.0 Control via PC
External ac power supply (Optional: Battery Pack)
AniCAM Case: 37 x 30 x 17.5 cm (W x D x H)
AniCAM with Case: 5 kg / 11.0 lbs
Humidity: 40% – 60%, non-condensing
Annual Service Contract
WEB-based training and support
X-axis micro adjustment for an exact axial positioning of the camera. (Increases the minimum roll/cylinder diameter to 81mm)
Y-axis micro adjustment for an exact transverse positioning of the camera. (Increases the minimum roll/cylinder diameter to 81mm)