Troika Systems Limited are the leading manufacturer of 2D and 3D scanning microscopes for the printing industry. Troika has set new standards for quality assurance in the printing, embossing and coating markets with its easy-to-use AniCAM and SurfaceCAM 3D scanning microscopes. There are now over 1,500 AniCAM and SurfaceCAM 3D systems in operation globally. Our customers include; flexographic, gravure and coating printers, Anilox, Gravure & Flexoplate manufacturers.

AniCAM Anilox QC

An optional software module for volume and geometric measurement of non-hexagonal cells allows you to measure any type of engraving 

AniCAM Gravure QC

The AniCAM Gravure QC was developed for gravure printers where Management and Quality Control of their cylinders is desired.

AniCAM™ FlexoPlate QC

The AniCAM Flexoplate QC Workflow provides two reading methods: 2-dimensional readings with an automatic reflective or translucent dot detection and a 3-dimensional analysis.

SurfaceCAM

Knowing the condition of the anilox rolls for a printer converter has been proven to save considerable press setup time and reduce waste which
inevitably increases profitability

MagneCAM

Positioning an AniCAM or SurfaceCAM on steel cylinders/rolls rotated at any angle incorporating magnetic legs and special internal drive couplings.

"We saw a reduction of 55% in ink waste"

Troika System hold honours for technical innovations in the flexographic printing industry

,

"During the past 12 months we made a saving of 15% in make-ready waste"

Troika System hold honours for technical innovations in the flexographic printing industry

,

"Having used the AniCAM for the past 6 months, we saw a saving of 29 hours per month in make-ready setup time"

Troika System hold honours for technical innovations in the flexographic printing industry

,